The TASK EDITOR is entered by turning the TL encoder one click to the left - from the Navigation ribbon menu. or by scrolling all the way to the right.
The last-entered active task will be displayed ... or a 'No Task' message will be displayed.
The BR encoder is used at his point to perform ALL task edit functions.
New Task Setup
1/ Press the BR encoder to display the list of turnpoints. The bottom highlighted row of the list will be '<<end>>'
2/ Press the BR encoder again to start new task creation.
3/ The initial task screen will display '**NoTask**' to indicate no turnpoints have been selected for this new task setup.
4/ Press the BR encoder to display the turnpoint list.
5/ Scroll down the list with the BR encoder to select a Start point. The first turnpoint selected is always assumed to be the start point and has the prefix 'S:' in the task display.
6/ The task will display the Start at the top of the list and '<<end>>' will be highlighted on the last line.
7/ Press BR encoder to display turnpoints. BR encoder will scroll through the list. Press the BR encoder to add the highlighted turnpoint to the task.
8/ The task will be display with the Start ... and the last selected turnpoint as Finish. The '<<end>>' will be highlighted.
10/ Continue add turnpoints to the bottom of the task using the BR encoder to scroll and select. The last selected turnpoint is always considered the Finish.
11/ When task construction is completed, depress and hold the BR encoder to display the save options.
- 'Cancel' discards the task. The CNv will revert to the last entered task.
- 'Declare - No' saves the task ... but does not initialize the declaration.
- 'Declare - Yes' saves the task ... and does initialize the declaration.
12/ When 'Declare - Yes' or 'Declare - No' is selected, the Start turnpoint becomes the active waypoint.
Active Task Edit
1/ Existing tasks can be edited by changing an existing turnpoint ... or by deleting all turnpoints at a certain point in the task turnpoint list.
2/ Highlight an existing task turnpoint and press the BR encoder to select a replacement from the turnpoint list.
3/ Highlight an existing turnpoint and press the BR encoder to select the turnpoint list. Selecting '<<end>>' at the top of the list will erase that turnpoint and all following. New turnpoints may be selected for the deleted turnpoints to specify the revised task.